Permatex Anaerobic Gasket Maker 515, 300ml Cartridge

51580

Details:

Flexible, gasketing material for use on rigid machined flanges with less than .015″ gap. OEM approved use where OE s specify anaerobic gasket (cures in the absence of air). Withstands temperatures to 300F (149C). Eliminates preformed, pre-cut, paper, rubber and cork gaskets. Flexes with flanges that move in service.

Application:

Automobile

Suggested Applications:Water pumps, thermostat housings, transmission pans, transmission case covers, engine cases, timing covers, transaxle casings, o-ring replacement

Instruction:

TO MAKE A GASKET:

1. Clean both flange surfaces. Remove paint, dirt, grease or old gasket completely.
2. Spray Permatex Surface Prepactivator on one surface only. Allow to dry 1-2 minutes.
3. Apply a continuous bead of sealant to the unprimed surface.
4. Assemble mating surfaces with minimal lateral movement. Excess sealant can be wiped awaywith a cloth and shop solvent.

TO DRESS A GASKET:

1. Clean both flange surfaces. Remove paint, dirt, grease or old gasket completely.
2. Spray Permatex Surface Prepactivator to both flange surfaces. Allow to dry 1-2 minutes.
3. Completely cover both sides of the precut gasket with sealant.
4. Place coated gasket on flange, and assemble mating surfaces with minimal lateral movement.